For buyers comparing indoor LED screen prices in South Africa, the cabinet price alone is not the full project cost. Pixel pitch, screen area, controller, spare parts, shipping, installation, and support all affect a final quote. This case documents the supplied specification so buyers can compare proposals on the same scope. Explore EagerLED’s indoor LED screen solutions or request a project-specific quotation.
The system uses P2.5 320 x 160 mm indoor magnetic LED modules installed in EA640F1 640 x 480 mm cabinets. Each 6 x 5 video wall contains 30 cabinets, so the two-screen project accounts for all 60 cabinets. The finished dimensions of each display are 3.84 m wide by 2.4 m high.
A 3840 Hz refresh rate helps reduce visible scan lines when the display is filmed for presentations, events, or social media. Magnetic module mounting also allows technicians to remove an individual module from the viewing side without taking down the complete video wall.
The EA640F1 cabinet uses a full front-service design. LED modules, power supplies, and receiving cards can be accessed from the front of the screen, which is useful when the display is installed close to a wall and rear service clearance is limited.
For routine maintenance, a technician can inspect the affected cabinet and replace the relevant component from the viewing side. Power and signal cabling should still be planned before installation so every 640 x 480 mm cabinet remains accessible and the 6 x 5 alignment stays consistent.
Each cabinet in this South Africa project uses a NovaStar DH7512 receiving card to distribute video data to the LED modules. Matching the receiving-card configuration across all 60 cabinets supports consistent signal mapping between the two screens. For controller software, downloads, and current manufacturer information, refer to the official NovaStar LED control system website.
The supplied cabinets use the BoQiang Q200-4.5-B power supply. The component specification for this project is 200-240 VAC input and 5 V, 60 A output. Installers should confirm local electrical requirements, circuit capacity, grounding, and protection before commissioning the complete indoor LED display.
Watch the P2.5 indoor LED display project video to inspect the 640 x 480 mm cabinets, front-service components, module construction, and final screen configuration. The footage provides a practical reference for buyers evaluating a comparable indoor advertising screen or video wall.
